SLUMP TEST APPARATUS, DIGITAL LENGTH COMPARATOR, SHRINKAGE BAR MOULD, VIBRATING TABLE, 1M X 1M FOR 16 MOULDS OF 150MM CUBE, manufacturers suppliers in India

VIBRATING TABLE, 1M X 1M FOR 16 MOULDS OF 150MM CUBE

TECHNICAL DETAIL
Ref. : EN 12350-6, 7, 12390-2, 13286-50

The table top be suitable to hold cube moulds and has stops along its edges to prevent moulds from sliding off the table during operation. The specially designed Vibro motor for operating the vibrator. Suitable for operation on 220 V, 50 Hz, Single Phase, AC supply.

•Vibrating Table, Table top 1M X 1M for 16 moulds of 150mm cube

SHRINKAGE BAR MOULD

TECHNICAL DETAIL
Shrinkage Bar Mould, two compartments with knurled and threaded reference point, Knurled and Threaded Reference Points

DIGITAL LENGTH COMPARATOR

TECHNICAL DETAIL
For Drying, Shrinkage and Moisture Movement

Ref. Standards IS:4031, IS:9459, ASTM C490 and BS: 1881, EN-1367-4

For determination of change in size of a concrete or cement sample, brought

about by a change in moisture content,

The apparatus can be used for three basic tests:

Initial drying shrinkage

•The difference between the length of the cured specimen and the length when it is dried.

Drying shrinkage

•The difference between the length of the specimen from existing structure and its length when completely dried.

Moisture movement

•The difference between the length of the dried specimen and its length when again saturated with water.

The equipment consist of following replaceable parts :

•Length Comparator Frame

•Reference Bar

•Digital Dial Gauge 0-25mm x 0.001mm

SLUMP TEST APPARATUS

TECHNICAL DETAIL
Ref. Standards IS:7320, BS:1881 , ASTM C 143,AASHTOT119
The slump cone is filled with freshly mixed concrete and is tamped with a tamping bar in four layers. The top of the concrete is levelled off with the top of the slump cone, the cone is lifted vertically up and the slump of the sample is immediately measured. Base has cleats on its underside to help dig into the ground surface. Positive clamping of slump cone to the base while filling and tamping the concrete.
A combination swivel carrying handle also serves as the datum making the conventional and somewhat awkward measuring procedure of using a foot rule and a datum bar, a thing of the past.
The equipment consist of following replaceable parts :
Slump Cone Base plate with cleats & swivel handle Tamping rod steel, 10 mm dia x 600 mm length with ISI certification mark IS : 10086

Prev 1 2 3 4 5 6 7 8 Next

SLUMP TEST APPARATUS DIGITAL LENGTH COMPARATOR SHRINKAGE BAR MOULD VIBRATING TABLE, 1M X 1M FOR 16 MOULDS OF 150MM CUBE