VIBRATING TABLE, 1M X 1M FOR 16 MOULDS OF 150MM CUBE, JOLTING APPARATUS, PULVERISER THREE PHASE, NEW MODEL, JAW CRUSHER, THREE PHASE, PULL OUT BOND TEST FOR CONCRETE, manufacturers suppliers in India

PULL OUT BOND TEST FOR CONCRETE

TECHNICAL DETAIL
Digital Rebar Pull-Out Force Tester with Steel Hydraulic Cylinder, 30 tons capacity, with LPI batter

JAW CRUSHER, THREE PHASE

TECHNICAL DETAIL

1.Designed to speed-up crushing of aggregates, Ores, Mineral, Coal and similar materials.

2.Compact and rugged for laboratory and small production units.

3.Manganese steel jaws adjustable upto 6 mm opening. 4.250kg materials can be crushed in approx. eight hours

5.Discharging opening adjustment range: 3-1 0mm

6.Supported with strong steel frame.

7.Suitable to crush any type of stone up to 45mm.

8.Suitable for cement and chemical laboratories.

9.Suitable for operation on 415V, 50Hz, 3 Phase, AC supply.

PULVERISER THREE PHASE, NEW MODEL

TECHNICAL DETAIL

Designed for grinding materials to produce fine mesh samples , suitable to grind up to 150 micron. The motor & gear assembly would be supported by two nos. of bearing blocks and mounted on sliding carriage. The gap of two grinding wheels be adjustable by rotating wheel of sliding carriage.

Specifications:

•Dia of Grinding Wheel - 175mm

•Material for Grinding Wheel High Carbon Steel having 55-60 HRC Hardness

•Input Size of Material < 6mm

•Output size of Material ; >.150 μ

Suitable for operation on 415V, 50Hz, 3 Phase, AC supply.

JOLTING APPARATUS

TECHNICAL DETAIL

Ref. Standard - IS:10078, EN-196-1-13454-2

The Jolting apparatus consists of a rectangular table, rigidly connected by two support arms to spindle at a horizontal distance of 800 mm from the centre of

the table. The table may be allowed to be raised and fall freely by a cam

connected to a motor with rotation at a rate of 60 rpm. A digital counter with sensor is provided, which stops the machine after 60 jolts. Locating pins are provided for mounting the mould compartments on the table. The mould, surrounded by the hopper, can be clamped rigidly to the table. Supplied complete with mould and hopper. Suitable for operation with 220V, 50 cycles, single phase, AC Supply.

The equipment consist of the following replaceable parts : Counter, Aluminum hopper, Jolting Mould

Mould for Flexural Prism

Steel, three compartments, each of 40 x 40 x 160 mm

VIBRATING TABLE, 1M X 1M FOR 16 MOULDS OF 150MM CUBE

TECHNICAL DETAIL

Ref. : EN 12350-6, 7, 12390-2, 13286-50

The table top be suitable to hold cube moulds and has stops along its edges to prevent moulds from sliding off the table during operation. The specially designed Vibro motor for operating the vibrator. Suitable for operation on 220 V, 50 Hz, Single Phase, AC supply.

•Vibrating Table, Table top 1M X 1M for 16 moulds of 150mm cube

Prev 1 2 3 4 5 6 7 8 Next

VIBRATING TABLE, 1M X 1M FOR 16 MOULDS OF 150MM CUBE JOLTING APPARATUS PULVERISER THREE PHASE, NEW MODEL JAW CRUSHER, THREE PHASE PULL OUT BOND TEST FOR CONCRETE