TECHNICAL DETAIL
Vibrating Table, 50 x 50cm for 4 moulds of 150mm cube having Proper compaction of cement concrete while casting specimens for compression testing is essential to achieve higher compressive strength. The table top is suitable to hold cube moulds and has stops along its edges to prevent moulds from sliding off the table during operation. The specially designed vibro motor for operating the vibratory. Suitable for operation on 220 V, 50 Hz, Single Phase, AC supply. Capacity 0.5 to 1 ton, the height of the table from the ground level shall be sufficient to allow for easy placing and removal of the moulds and shall not exceed
0.75 metre. frequency of vibration for the table operating at its maximum load capacity shall be between 3000 to 6000 cycles per minute. IS Code:2514-1963. |